Plumsteadville HVAC Pros logo Plumsteadville HVAC Pros

2026-08-28 · Frank Reilly

Fall HVAC Checklist for Bucks County Homes: Gas, Oil, Propane & Heat Pumps

Fall HVAC Checklist for Bucks County Homes: Gas, Oil, Propane & Heat Pumps

The first cold night in Bucks County usually lands in October, and it's the busiest night of the year for no-heat calls. Most of those failures are preventable. This checklist covers what you can do yourself in an afternoon, and what each type of heating system common around Plumsteadville, Doylestown and New Hope needs from a technician before winter.

Do-it-yourself fall checklist

  • Test the heat early. Switch the thermostat to Heat on a mild September or early October day and raise the setpoint a few degrees. A burning-dust smell for the first few minutes is normal. A system that won't start is much easier to fix now than on a 20°F night.
  • Change the filter. Start the heating season with a clean one. See How to Check and Change Your AC Filter.
  • Test smoke and carbon monoxide alarms. Replace batteries and make sure there's a CO alarm on every level with fuel-burning equipment.
  • Clear around equipment. Keep at least 3 feet around furnaces, boilers and water heaters free of boxes and stored items.
  • Check fuel. Oil and propane homes should schedule a fill before the first cold stretch. Don't let an oil tank run low; it can pull sludge into the burner.
  • Clear the outdoor unit. Leaves pile up fast in wooded Plumstead Township yards. A heat pump needs clear airflow all winter; keep 2 feet clear around it.
  • Check exhaust vents. High-efficiency furnaces vent through PVC pipes on an outside wall. Make sure leaves, nests and, later, snow don't block them.

What a technician should check, by system type

Gas and propane furnaces (common in Doylestown borough, Chalfont and New Britain, and propane in rural townships): clean the flame sensor, inspect the igniter, check gas pressure and burners, test the pressure switch and inducer, clear the condensate trap on high-efficiency units, inspect the heat exchanger where accessible, and measure carbon monoxide. See furnace & heating repair.

Oil furnaces and oil boilers (common in older homes and farmhouses in Plumstead, Bedminster and Solebury Townships): replace the nozzle and oil filter, clean the combustion chamber and flue passages, check the cad cell and ignition, and run a combustion test. Annual oil burner service is the single best way to avoid a January lockout.

Hot-water and steam boilers: check system pressure (about 12–15 psi cold on most hot-water boilers), test the relief valve, check the expansion tank charge, bleed air from radiators, and on steam systems check the water level and low-water cutoff. See boiler repair.

Heat pumps: check the refrigerant charge, test the defrost cycle and reversing valve, confirm backup heat stages on only when needed, and make sure the outdoor unit sits high enough above snow and drains defrost water. See heat pump repair.

Things homeowners shouldn't do

Inspecting a heat exchanger for cracks, adjusting gas pressure and working on oil burners all require training and instruments. If you smell gas, leave the house and call PECO or your propane supplier and 911 from outside.

Signs to book service now, not later

  • A furnace that lights, then shuts off after a few seconds
  • An oil burner that needed its reset button pressed last winter
  • Radiators that were slow to heat or banged loudly
  • A heat pump that ran on "Aux" or "Emergency" heat a lot last year
  • Soot, a fuel smell, or a yellow instead of blue gas flame

We handle fall heating service across Plumsteadville, Pipersville, Doylestown and Buckingham, with 24/7 emergency service if the heat goes out.

Need AC Repair or Heating Repair in Plumsteadville, PA?

Talk to a local AC and heating repair team on Route 611 serving Plumsteadville and central Bucks County.

Call now Get a quote